4
SAFETY MARKINGS
1. Always inspect the jack before using, replace if damaged or malfunctioning. Do not remove any of the
labelsfrom the jack.
2. Always ensure the jack is used on a hard at and level surface
3. Never lift any load over the rated capacity.
4. Always center jack under load.
5. Never allow load to tilt on the jack as the jack may kick out causing injury to the operator and/ or cause the
load to fall.
6. When using more than one jack to lift a load, each jack must have the same lifting capacity of the entire
load being lifted.
7. Never force the lifting screw past its safety stop, as the screw may come out of the jack and result in
personal injury and properly damage.
8. Always keep the screw lubricated for ease of operation and prevent against rust.
9. Study, understand, and follow all instructions before operating this device.
10. No alterations shall be made to this product.
11. Support only secure and stable components before raising load.
12. Never use on a lawn mower or lawn tractor.
13. Only attachments and/or adapters supplied by the manufacturer shall be used.
14. Not for use on passenger vehicles, saddle has a a built in tilting mechanism which is not designed for
passenger vehicles, buses, or tractor/trailers.
15. Do not use if damaged in any way.
16. Failure to heed these markings may result in personal injury and/or property damage.
WARNING!
To Next Page
Loading...
