www.bigstone-nj.com
Address：NO.38 Ningliu Road, Pukou District, Nanjing City, China
Tel：025-89618445
Fax：025 – 58849541
Email: bigstone.ebike@gmail.com
10.3 C Parameter Setting
In the P parameter Settings interface， hold the SET for 3 seconds
and enter into the C parameter setting interface. Click the SET to cycle
from C1 to C7 setting interface, press UP or DOWN to select the wanted
parameter, and hold the SET for 6 second to exit.
10.3.1、C1: Power-Assist Sensor and Parameter Select Setting
C1 is power-assist sensor and parameter select setting, its definition
is shown in following table.
C1 parameter definition table：
To Next Page
Loading...
