BIGTREETECH
11 / 11
3. If an uninitialized CAN device is detected, the above command will report the
device's canbus_uuid:
Found canbus_uuid=0e0d81e4210c
4. If Klipper is already running and connected to this device, the canbus_uuid will
not be reported, which is normal.
6. Precautions
1. 12/24V and GND should be connected correctly.
2. When using CAN communication, you need to see which CAN node is used as
a terminal. If using a terminal, you must plug the jumper cap at the 120R position.
To Previous Page
Loading...
Need help?
General
