VoIP/(802.11g) ADSL2+ (VPN) Firewall Router
Chapter 4: Configuration
120
Special Dial Codes
The following table lists the special dial codes that are built-in to the system:
Option Description
Flash-hook
(Wireless Router with
LINE port only)
Switch to PSTN line
Note: A quick press of the hook. On some phones a button is
provided which provides Flash-hook functionality. The button is
marked "FLASH" or "RECALL".
*69
Return the last missed call for SIP service only
Note: Entering this on a phone will call the last number which
made a call to the phone. For example A makes a call to B, but
hangs up before B answers. If B enters *69, A will be called.
##
Last number redial
*20
Set do not disturb on
Note: It is possible to set a Do-Not-Disturb feature on a phone
such that any phone which calls the phone will receive an engaged
tone and the phone called will not ring. For example, B enters *20
and hangs up. A makes a call to B, and receives the engaged tone
and phone B does not ring.
*80
Set do not disturb off
*74<x><number>#
Set the number for Speed dial code ‘x’, where ‘x’ is a number
between 2 and 9.
Note: Where <x> is a number between 2 and 9, and <number> is
the number to dial. The code needed to dial a speed dial from a
phone connected to a VoIP Router is:
<x>#, where <x> is a number between 2 and 9.
The settings will infect to your setting in Speed Dial on WEB GUI.
*90<phone-number>
Set the number for performing Blind Call Transfer, where
<phone-number> is the number that you wish to transfer the call
to. It’s for SIP service only.
Note: In Blind Call Transfer, you have a call in progress
(incoming or outgoing) and decide you wish to transfer the call to
another phone. To transfer the call, perform the following steps:
1. Hook-flash to get a dial tone.
2. Dial *90<phone-number> (e.g. *907401), there will be a
confirmation tone then hang up. The other end will hear ring back
and the called third-party phone will ring. When the third-party
phone is picked up the two calls will be connected.
If the third-party phone does not answer then the caller being
transferred can hang up to cancel the connect attempt.
To Next Page
Loading...
