VoIP/(802.11g) ADSL2+ (VPN) Firewall Router
Chapter 4: Configuration
43
PPPoA Routed Connections
Description: User-definable name for the connection.
VPI/VCI: Enter the information provided by your ISP.
ATM Class: The Quality of Service for ATM layer.
NAT: The NAT (Network Address Translation) feature allows multiple users to access the Internet through
a single IP account, sharing a single IP address. If users on your LAN have public IP addresses and can
access the Internet directly, the NAT function can be disabled.
Username: Enter the username provided by your ISP. You can input up to 128 alphanumeric characters
(case sensitive). This will usually be in the format of “username@ispname” instead of simply “username”.
Password: Enter the password provided by your ISP. You can input up to 128 alphanumeric characters
(case sensitive).
IP Address: Your WAN IP address. Leave this at 0.0.0.0 to automatically obtain an IP address from your
ISP.
Authentication Protocol Type: Default is Chap (Auto). Your ISP will advise you whether to use Chap or
Pap.
Connection:
~ Always on: If you want the router to establish a PPPoA session when starting up and to
automatically re-establish the PPPoA session when disconnected by the ISP.
~ Connect on Demand: If you want to establish a PPPoA session only when there is a packet
requesting access to the Internet (i.e. when a program on your computer attempts to access the
Internet).
To Next Page
Loading...
