VoIP/(802.11g) ADSL2+ (VPN) Firewall Router
Chapter 4: Configuration
48
PPPoE with Pass-through Connections
PPPoE with pass-through adapts the following method: PPPoE Routed mode + 1483 Bridge Mode. With
pure PPPoE connection, the router can get one WAN address to the router. With the PPPoE and
PPPoE pass-through, concurrently, it allows user to have a WAN address assigned to the router but also
able to get another WAN IP from ISP using PPPoE dialer (e.g WinPoETor Windows XP PPPoE Dialer) at
the same time.
Description: User-definable name for this connection.
VPI/VCI: Enter the information provided by your ISP.
ATM Class: The Quality of Service for ATM layer.
NAT: The NAT (Network Address Translation) feature allows multiple users to access the Internet through
a single ISP account, sharing a single IP address. If users on your LAN have public IP addresses and can
access the Internet directly, the NAT function can be disabled.
Username: Enter the username provided by your ISP. You can input up to 128 alphanumeric characters
(case sensitive). This will usually be in the format of “username@ispname” instead of simply “username”.
Password: Enter the password provided by your ISP. You can input up to 128 alphanumeric characters
(case sensitive).
Service Name: This item is for identification purposes. If it is required, your ISP will provide you the
information. Maximum input is 20 alphanumeric characters.
IP Address: Your WAN IP address. Leave this at 0.0.0.0 to automatically obtain an IP address from your
ISP.
Authentication Protocol: Default is Chap (Auto). Your ISP will advise you whether to use Chap or Pap.
Connection:
~ Always on: If you want the router to establish a PPPoE session when starting up and to
automatically re-establish the PPPoE session when disconnected by the ISP.
~ Connect on Demand: If you want to establish a PPPoE session only when there is a packet
To Next Page
Loading...
