EasyManuals Logo

Billion SG3010 Series User Manual

Billion SG3010 Series
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
12
Un-pairing the smart meter
If you attemp to disconnect the the smart meter and leave the current network group, do the
following un-pair setup steps. Please note that before pairing the ZigBee coordinator with smart
power meters, check if the status LED of the smart meter lights green. If the status LED blinks
green,itmeansthatthemeterhasbeenpaired.Pleaseun-pairthesmartmeterrst.
Step 1: Cut off the power source of your smart meter and then turn on the power meter again.
Step 2: Press and hold the hidden button within 5~35 seconds after power on and then the LED
will blink around 6 seconds.
Step 3: Cut off the power source during the blinking and then turn on the smart meter again. Then
you can see the LED lights green steady. You have successfully un-paired the smart meter.
Please note that before the smart meter is power on, remember to shut down the
ZigBee coordinator in case the meter is paired to the device again.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Billion SG3010 Series and is the answer not in the manual?

Billion SG3010 Series Specifications

General IconGeneral
BrandBillion
ModelSG3010 Series
CategoryMeasuring Instruments
LanguageEnglish