7
Connecting the Power Meter
It is easy to connect SG3010/SG3015-T1/T2/T3/T4 simply by performing the following instructions.
Note: Ensure that the Power Meter is turned off or the power supply is cut off before
beginning setup.
SG3010/SG3015-T1
1. Plug in the electrical appliance that you intended to monitor to the Power Meter’s
outlet.
2. Plug the Power Meter directly into the wall outlet/socket.
3. Set up the connection between SG3010/SG3015 - T1 and ZigBee Coordinator (Please refer
to Networking Setup section).
4. After use, extract the appliance’s plug and then pull out the plug from the wall to complete
the power-off procedure.
To Next Page
Loading...