Color profile: Generic CMYK printer profile
Composite Default screen
PIN code
1
2
http://www.binatone .com/ 39
Customise your phone system
3
4
5
Press the PHONE/OK button then
Press the MENU button, then
the or button
▲ ▼
B A S E
or
▲ ▼
TONE, but if you use the phone as an extension
on a PBX, you may need to change to PULSE.
to go to
d i a l m o d e
button to
Dial mode
1
2
This is the system PIN -- a four-digit code you may
The default PIN is 0000; you can change it to any
itgit number you' ll remember.
Press the MENU then to go
Press the PHONE/OK button twice
the or button
▲ ▼
to
The display shows
Ú
B A S E
. If the current
Key in the current PIN and confirm using
Key in the new PIN and confirm using
The display shows
Key in the new PIN again and confirm u
sing
(If you key in a wrong PIN code on step, the display
have to repeat above steps.)
PHONE/OK button
The display shows
Ú
Ú
PHONE/OK button
The PIN code is changed after ‘beep’.
Ú
P I N
N E W
P i n
PIN is still at default 0000, it will skip this input.
N E W
will exit the setting, you
need if you want to register new handsets to your
base unit or access your answering machine remotely.
four-d
P I N
C O D E
PHONE/OK button
You should normally leave the this setting at
online
To Next Page
Loading...
