FED (E2) 02/2015 page 45/60
Standard equipment (continued)
Temperature safety device class 2 acc. to DIN
12880:2007 with visual temperature alarm
ļ¬ ļ¬ ļ¬ ļ¬ ļ¬
ļ¬ ļ¬ ļ¬ ļ¬ ļ¬
Rear exhaust duct, internal diameter 50 mm / 1,97
inch with ventilation slide
ļ¬ ļ¬ ļ¬ ļ¬ ļ¬
Adjustable air change by means of rear exhaust
duct (50 mm) with ventilation flap and front
ļ¬ ļ¬ ļ¬ ļ¬ ļ¬
Four castors (2 lockable)
ļ¬
ļ¬ ļ¬ ļ¬ ļ¬ ļ¬
RS 422 interface for communication software APT-
COM⢠DataControlSystem, or switch over to
printer output with RS 232/RS 422 interface
ļ¬ ļ¬ ļ¬ ļ¬ ļ¬
Access ports with various diameters, with silicone
plug
ļ ļ ļ ļ ļ
Rack, chrome-plated or stainless steel
ļ ļ ļ ļ ļ
Perforated rack, stainless steel
ļ ļ ļ ļ ļ
ļ ļ ļ ļ ļ
Reinforced rack stainless steel, with 1 set rack
lockings
-- --
ļ ļ ļ
Reinforced inner chamber with 2 reinforced racks
ļ ļ ļ
Rubber pads for safe stacking (4 pieces)
ļ ļ ļ
Temperature safety device class 3.1 acc. to DIN
ļ ļ ļ ļ ļ
Disconnectable audible over-temperature alarm
ļ ļ ļ ļ ļ
Door with window and interior lightning
ļ ļ ļ ļ ļ
ļ ļ ļ ļ ļ
FKM door gasket (temperature resistant up to
200 °C)
ļ ļ ļ ļ ļ
HEPA Fresh air filter, class H 14 (DIN EN 1822)
ļ ļ ļ ļ ļ
Measurement of air change rate acc. to ASTM
D5374
ļ ļ ļ ļ ļ
Increased air change by stronger fan
ļ ļ ļ ļ ļ
ļ ļ
Inert gas connection (gas inlet and outlet), with
ļ ļ
-- -- --
Analog output 4-20 mA for temperature with 6 pole
DIN socket, DIN plug included
ļ ļ ļ ļ ļ
ļ ļ ļ ļ ļ
Temperature calibration including certificate
ļ ļ ļ ļ ļ
Spatial temperature measurement including
certificate
ļ ļ ļ ļ ļ
ļ ļ ļ ļ ļ
Chamber acc. to cUL standard in 115V 1N~60Hz
ļ ļ
Chamber acc. to cUL standard in 208 V 3N~60Hz
ļ ļ ļ
ļ ļ
Sturdy trolley, castors with locking brakes
ļ ļ ļ ļ
Legend: ļ¬ Standard equipment ļ Optional -- Not available