EN
12 3
1
2
3
4
5
6
Shaft Assembly
Assembly Tool
CAM Radial pitch offset
Hold assembly tool (502512) in a vice (flats provided) and install middle shaft.
Place CAM onto middle shaft ( with 'Top' engraving facing the shaft).
Place the base shaft on top of the CAM, align the holes and screw in the M10 x 70 cap head screws using
Loctite 243 and tighten to 65Nm.
Lift the assembly off of the assembly tool, rotate assembly and place back onto tool to complete
assembly.
Place the second CAM (with 'TOP' engraving facing up), ensure the CAM is 3 holes radially out of pitch
from the first CAM.
Fit top shaft, align holes and screw M10 x 20 cap head screws in using loctite 243 and tighten to 65Nm.
77-3229 R4.1 17/36 www.carlisleft.com
To Next Page
Loading...
