Binks E4-60 - Maintenance Schedule

EN
Maintenance
Maintenance schedule
Inspection Operation
Daily Check for any fluid leakage
Weekly
6 Monthly
Grease Main Shaft Bearing with 502375 grease.
Inspect Linear Bearings, Rod, Cam and Cam followers for excessive wear, replace
if excessive wear can be felt or seen.
Annually
Inspect Piston and Replace Piston Seals / Bellows / Springs.
Inspect Piston & Outlet Ball Checks, replace as necessary.
Inspect Linear Guide Bearing and Guide Rails for excessive wear.
Inspect Cam and Cam followers for excessive wear, replace if excessive wear can
be seen.
Every 5 Years
Replace main shaft bearings. Linear Guide Bearings, Guide Rails and Cams if
excessive wear can be seen.
Use only 502375 (KP2N-20 DIN 51825) Grease for Cam Follower Bearing.
Check for any excessive mechanical noise
Check for excessive fluid pressure pulsation
Check oil level within gearbox
3 Monthly
While running, apply (502375) grease to cam follower bearings, 8 strokes of a
standard ‘cartridge’ grease gun (502373).
77-3229 R4.1 25/36 www.carlisleft.com