EN
e.g.,
Suction -
Outlet -
Ø38 - 50 I.D. [20 bar working pressure]
Ensure adequate air space around the Pump for maintenance and electric motor cooling requirements.
Check that the oil plug on top of Gearbox has been replaced with the correct venting plug.
The vent plug is supplied in a bag attached to the gearbox.
(The gearbox is filled with the correct amount of oil at the factory)
Ø50 I.D. [-1 to 10 bar working pressure]
Attach suitable flexible hoses to the inlet and outlet connections.
Ensure the gearbox is filled with oil.
INSTALLATION
77-3229 R4.1 8/36 www.carlisleft.com
To Next Page
Loading...
