grip. Adjust them if necessary.
4. Inspect all hardware and tighten if necessary.
5. Inspect electrical controls. Verify all switches are working.
6. Adjust the valve clearance: set the intake valve to 0.003 inches and
the exhaust valve to 0.003 inches. **NOTE** Valve clearance can only be
checked and adjusted with the engine cold. Allow the vehicle to sit for at
least 2 hours after riding to ensure proper adjustment.
7. Check turn signal lights, headlight, taillight, and running lights.
Failure to perform the oil change
and valve adjustment during the
first 500 miles will void the
warranty! It is important to have
this work done at an authorized
Bintelli service center!
Level 1 Service and Maintenance
Level 1 Service and Maintenance should be performed every time after
the vehicle runs 1000-1500 miles.:
1. Adjust the travel of the front brake to 1/4- 3/4 inches, and adjust the
rear brake to 3/4-1 inch.
2. Adjust the travel of the throttle cable up to a 1/4 inch. Make sure the
throttle is closed at idle. Lubricate the throttle grip and the throttle
cable.
3. Inspect/clean the carburetor, fuel tank, oil filter screen and air filter if
necessary.
4. Adjust the idle speed of the
temperature, ensure the rear wheel is not spinning at idle.
5. Remove and inspect the spark plug. If there is any carbon deposits,
clean or replace and adjust the electrode gap spark plug to 0.025
inches.
6. Inspect battery terminals. Clean
tightness of connections.
7. Check all body components for fit. Verify all hardware is secure and
in place.
8. Verify the valve clearance: intake valve: 0.003 inches
exhaust valve: 0.003 inches
To Next Page
Loading...