Bintelli Sprint - Service and Maintenance for the Front Brake

30
Service and Maintenance USER’S MANUAL
Adjustment of the accelerator handgrip
Check whether the free travel of the throttle grip is within the specified
range and adjust if necessary. Please follow the following steps to adjust
the throttle free travel:
1. First, loosen the locking nut.
2. Spinning the regulator
will extend or shorten the free travel of the
throttle.
3.
When the desired setting is reached, tighten the locking nut and slide
the protective covering back over the regulator.
Service and Maintenance for the Front Brake
Most models use a front disc brake, which features high heat dissipation
and increased performance.
Adjustment of the front disc brake
1. Place the scooter on the rear kick stand.
2. Adjust the regulating nut of the front brake to adjust the free travel of
the front braking handgrip to 1/4 -1/2 inch.
The throttle grip should work
smoothly.
Any signs of
sticking or binding should be
addressed prior to riding the
vehicle.
Regulator
Locking nut
Adjust the free travel of the front braking handgrip between ¼ and ½ inch