Bintelli Sprint - Brakes

44
Service and Maintenance USER’S MANUAL
Common Faults and Troubleshooting
Fault system
Fault
Causes
Troubleshooting
Rear Wheel The rear wheel vibrates.
The rear wheel is damaged.
Replace the rear wheel.
The tire pressure is too low.
Increase the tire pressure.
The rear wheel nut is loose.
Torque the rear wheel nut to the proper specification
Suspension system
The shock absorber no
longer rebounds
The spring of the shock absorber is worn out
Replace the spring of the shock absorber
The shock absorber is improperly adjusted.
Re-adjust the shock absorber
Brakes Poor braking performance
The master cylinder has air in it
Bleed the brake lines
The front brake pads are worn
Replace front brake pads/ bleed lines
The rear disc pads are worn
Replace rear brakes/ adjust brake cable
Contaminated or old brake fluid
Flush and bleed brake lines
Lights
The head light will not turn
on
The head light bulb is burnt out .
Replace the head light bulb.
The headlight switch is faulty.
Inspect headlight switch wires/ replace
The connecting plug is loose.
Check the plug connector
The fuse is burnt out
Replace the fuse.
The battery is dead
Charge the battery
Stator issue
Check stator connections/ replace