Biobase BBS-H1300 - User Manual

Questions and Answers

M
Michelle FlemingAug 10, 2025
What to do if the UV lamp fails to work in my Biobase Laboratory Equipment?
- L
  lawrenceprattAug 11, 2025
  If the UV lamp in your Biobase Laboratory Equipment isn't working, ensure the front window is fully closed, as the LED lamp and blower won't operate otherwise. Also, check the circuit and make sure the tube and lamp holder are tightly connected. Other solutions include replacing the UV lamp tube, checking if the micro switch is broken, or replacing the control panel.
M
Mary WilsonAug 17, 2025
What to do if the LED lamp fails to work in my Biobase BBS-H1300 Laboratory Equipment?
- L
  Lucas AdamsAug 18, 2025
  If the LED lamp in your Biobase Laboratory Equipment isn't working, try these steps: connect the tube and lamp holder tightly, replace the lamp, check the circuit, connect the plug and stand tightly, replace the stand, replace the ballast, or replace the control panel.
S
Sharon MasonAug 26, 2025
What to do if the blower fails to work in my Biobase BBS-H1300 Laboratory Equipment?
- R
  Rachel CraigAug 26, 2025
  If the blower in your Biobase Laboratory Equipment is not working, check if the micro switch is broken. If the blower is defective, replace it. Also, check the circuit and consider replacing the control panel.
M
Michelle OwensSep 2, 2025
What to do if the button fails to work on my Biobase BBS-H1300?
- C
  catherineharmonSep 2, 2025
  If a button on your Biobase Laboratory Equipment isn't working, first ensure the power is well connected. Then, check if the button itself is broken and make sure the connecting wire is properly connected. If problems persist, consider replacing the control panel.