5400230 Rev. H
7.3 SYSTEM CONFIGURATION
The Settings Menu screen allows you to adjust the settings of the user interface. The Settings Menu
is entered by pressing and holding down the selector switch for approximately 1.5 seconds when in
the Main Screen while in Standby mode.
Figure 7-2:
Settings
Screen (A
iming beam currently
s
hown)
The following screens are available in the Settings Menu:
►
Aiming Beam: To modify the aiming beam brightness.
►
Restore All: To restore all procedures and preferences to their default settings.
►
Language: To select from the available languages
.
►
Exit: To exit the Settings Menu
Aiming Beam allows you to adjust the brightness of the aiming beam. To change the brightness,
select the
Increase
or
Decrease
arrow icons. The aiming beam has 3 brightness settings: level 1 is
the lowest setting and level 3 is the highest at 1mW output. Level 2 is the default setting.
The Restore All button will reset the aiming beam brightness. preset values, and language selection
to their default settings.
The Language selection will enable selection from up to 10 different languages.
To Next Page
Loading...