12 | 2. Advanced Menu
System probe lter
This item controls whether or not the probe lter is enabled. Has no eect on parts where the
probe lter is fuse disabled.
Opons: Auto (Default) / Disabled / Enabled
Memory interleaving
This item controls fabric level memory interleaving (AUTO, none, channel, die, socket).
Opons: Auto (Default) / None / Channel / Die / Socket
»
Note that channel, die, and socket has requirements on memory populaons and it will be ignored if
the memory doesn’t support the selected opon.
Memory interleaving size
This item controls the memory interleaving size. The valid uzlues are AUTO, 256 bytes, 512
bytes, 1 Kbytes or 2Kbytes. This determines the starng address of the interleave (bit 8, 9, 10 or
11).
Opons: Auto (Default) / 256 Bytes / 512 Bytes / 1 KB / 2 KB
Cannel interleaving hash
This item controls whether or not the address bits are hashed during channel interleave mode.
This eld should not be used unless the interleaving is set to channel and the interleaving size is
256 or 512 bytes.
Opons: Auto (Default) / Disabled / Enabled
UMC Common Opons