P4M800-M7A BIOS Manual
15
Write Recovery Time<TWr>
The Choices:4T (default).
DRAM Command Rate
This item controls clock cycle that must occur between the last valid write operation and
the next command.
The Cho ices: 1T Command, 2T Command (default).
RDSAIT Mode
The Choices: Auto(default).
RDSAIT Selection
The Choices:03(default)
AGP & P2P Bridge Co ntrol
If you high light the litera l “Press Enter” next to the “AGP & P 2P Bridge Control” labe l and
then press the enter key, it will take you a submenu with the following options:
AGP Aperture Size
Select the size of the Accelerated Graphics Port (AGP) aperture. The aperture is a portion
of the PCI memory address range dedicated for graphics memory address space. Host
cycles that hit the aperture range are forwarded to the AGP without any translation.
The Cho ices: 64M, 256M, 128M (default), 32M, 16M, 8M, 4M.
AGP 2.0 Mode
This item allows you to select the AGP Mode.
The Choices: 4X (default), 2X, 1X.
AGP Driving Control
By choosing “Auto” the system BIOS will the AGP output Buffer Drive strength P
Ctrl by AGP Card. By choosing “Manual”, it allows user to set AGP output Buffer Drive
strength P Ctrl by manual.
The Choices: Auto (default), Manual.
To Next Page
Loading...
Need help?
General
