www.BISSELL.com
6
Power On & Settings
Turn the dial on the foot of the vacuum to desired
setting. If dial is difficult to turn, tilt vacuum back.
WARNING
Before using your vacuum, make sure that the dirt container is in locked position and that
the filter is in place. DO NOT operate your vacuum without the filter.
Above Floor Cleaning
Bare Floor Setting -
For bare floors or low
pile carpet.
High Carpet Setting -
For high pile and most
shag carpet.
1
For extended reach, lift the
Quick Release Lever on the
back of the vacuum to slide
the Quick Release Handle
out of the base.
Pull hose up and out of
vacuum base to attach
your desired tool.
1
2
2
Install Febreze® Filter
*
Replace standard yellow
foam filter with Febreze®
black foam filter to freshen
as you vacuum.
Slide out the filter tray
located underneath the
dirt bin.
*Included separately
NOTE: Your vacuum
comes with a standard
foam filter (yellow)
located in the lower filter
tray of the dirt tank. A
separate Febreze® foam
filter (black) may also be
packed in the box. Both
are washable. Over time,
the Febreze® filter will
begin to lose scent after
use and washing.
1
2
Febreze® and related trademarks are owned by the Procter & Gamble Company,
Cincinnati, Ohio and used under license by BISSELL Homecare, Inc.
Press down once on the red ON/
OFF pedal located on the lower
back of the vacuum to turn ON.
Press down again to turn OFF.
Remove the hose from
the hose wand base and
connect to the open inlet at
the handle. Connect desired
tool to the end of the wand.
To Next Page
Loading...
Need help?
General
