8
Bare Floor Tool available for purchase at www.bissell.com
or BISSELL Consumer Services 1.800.237.7691.
Attach Bare Floor Tool to unit.
QuickSteamer (1970 series) — remove Brush before
attaching Bare Floor Tool.
Fill Clean/Solution Tank with BISSELL Hard Floor
Solutions
™
to formula fill line
Fill Clean/Solution Tank with hot (NOT BOILING) tap water
to the WATER fill line.
Turn Power Switch OFF.
Unplug Power Cord from outlet.
Remove and empty Collection Tank.
Release Collection Tank latches [1 each side] by
pulling up from bottom of latch and then out.
Carefully lift Collection Tank from Lower Body.
Carry Collection Tank to a toilet or sink. To empty,
pour out contents using opening at back of Tank.
Rinse Collection Tank thoroughly.
Remove lint and hair from Red Gasket in base of
unit. (Do not remove gasket)
Clean Nozzle Window by lifting latch and removing from
machine. Rinse under running water. When finished
replace Nozzle and secure with latch.
Replace Collection Tank on Lower Body and secure
with latches.
Wrap Power Cord around Quick Release Cord Wrap
™
on
side of QUICKSTEAMER
®
.
Wipe all surfaces with a soft cloth. Store cleaner upright in
a protected, dry area.
NOTE: You may have cleaning solution remaining in the
Clean/Solution Tank. You may store your QuickSteamer
this way for the next cleaning task, but never keep
soiled solution in the Collection Tank.
1.
2.
1.
a.
3.
2.
CAUTION:
Do not store unit
where freezing may
occur. Damage to
internal components
may result.
a.
b.
c.
e.
3.
4.
5.
6.
7.
Bare Floor Cleaning
WARNING:
To reduce the risk
of injury from moving
parts and/or electrical
shock, turn Power
Switch OFF and
disconnect plug
from electrical outlet
before performing
maintenance or
troubleshooting
checks.
Routine Maintenance
When You're Done
a.
b.
c.
d.
e.
4.
Dirty
lift by handle
ug603-5617_1970-2080_405.indd 8ug603-5617_1970-2080_405.indd 8 8/23/05 8:35:20 AM8/23/05 8:35:20 AM
To Next Page
Loading...
