Bissell QuickSteamer 2080 SERIES - Install Replacement Brush Belt

*QuickSteamer PowerBrush models only
Turn the machine off and unplug from wall outlet.
Remove Clean/Solution and Collection Tanks.
Lie machine down to access the bottom of the machine.
With a Phillips head screwdriver, unscrew the Brush
Cover and remove.
Remove the Brush End Cap and remove belt from brush.
Brush can now be removed.
Belt can be removed by sliding off the Motor Pulley.
Clean or replace belt. Attach belt to Motor pulley and
brush, insert brush into right side End Cap.
Reattach the left End Cap and slide brush back into place.
Replace the brush cover and screw into place.
To Install the Replacement Brush Belt
1.
2.
3.
4.
5.
6.
9
7.
8.
9.
10.
3. 4. 5.
5a. 6. 7.
8. 9. 10.
Brush Cover
ug603-5617_1970-2080_405.indd 9ug603-5617_1970-2080_405.indd 9 8/23/05 8:35:20 AM8/23/05 8:35:20 AM