Bistos BT-200 User Manual

BT-200 Operation Manual
11
P/N: 200-ENG-OPM-EUR-R06
Bistos Co.,Ltd
2018,03
Section 5 Declaration on EMC
5.1 Electromagnetic emissions
The BT-200 is intended for use in the electromagnetic environment specified below. The
customer or the user of BT-200 should assure that it is used in such an environment.
Emissions test
Compliance
Electromagnetic environment-guidance
RF emissions
CISPR 11
Group 1
The BT-200 uses RF energy only for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interference in nearby electronic equipment.
RF emissions
CISPR 11
Class B
The BT-200 is suitable for use in all
establishments by using a battery.
Harmonic emission
IEC61000-3-2
Not applicable
Voltage fulctuations
/flicker emissions
IEC61000-3-3
Not applicable
5.2 Recommended separation distances between portable and mobile RF
communications equipment and the BT-200
The BT-200 is intended for use in an electromagnetic environment in which
radiated RF disturbances are controlled. The customer or the user of the BT-200
can help prevent electromagnetic interference by maintaining a minimum
distance between portable and mobile RF communications equipment
(transmitters) and the BT-200 as recommended below, according to the
maximum output power of the communications equipment.
Rated maximum output
power of transmitter [W]
Separation distance according to frequency of transmitter[M]
150 kHz
to 80MHz
 = 1,2
√

80 MHz to
800 MHz
 = 1,2
√

800 MHz to
2.5 GHz
 = 2,3
√

0.01
0.12
0.12
0.23
0.1
0.38
0.38
0.73
1
1.2
1.2
2.3
10
3.8
3.8
7.3
100
12
12
23
For transmitters rated at a maximum output power not listed above, the recommended
separation distance d in meters (m) can be estimated using the equation applicable to the
frequency of the transmitter, where P is the maximum output power rating of the
transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1) At 80 MHz and 800 MHz, the separation distance for the higher frequency range
applies.
NOTE 2) These guidelines may not apply in all situations. Electromagnetic propagation is
affected by absorption and reflection from structures, objects and people.

Bistos BT-200 Specifications

General

Brand	Bistos
Model	BT-200
Category	Medical Equipment
Language	English