3. Configuring the Server
3. Configuring the Server
Setting up the Pool
To configure the server:
1. Click Settings marked below.
Note:
1. Fan speed percentage can be adjusted, but we recommend to keep the default setting. The server will
adjust the fan speed automatically if the fan speed percentage has yet been selected.
2. There are two working modes of S19j server: Normal mode and Sleep mode. The server enters the sleep
mode under the condition that the control board is powered while hashboards are not powered.
2. Set the options according to the following table:
Enter the address of your desired pool.
The S19j servers can be set up with three mining pools, with decreasing priority
from the first pool (pool 1) to the third pool (pool 3). The pools with low priority
will only be used if all higher priority pools are offline.
To Next Page
Loading...
