To Next PageTo Next Page
Need help?Do you have a question about the Bitzer CSV.2 and is the answer not in the manual?
General| Frequency | 50/60 Hz |
|---|---|
| Refrigerant | R134a |
| Cooling Capacity | Varies by model |
| Piston Displacement | N/A (Screw Compressor) |
| Sound Power Level | Varies by model |
| Weight | Varies by model |
| Motor protection | Integrated motor protection |
| Oil pump | Integrated oil pump |
Steps for preparing components before installation, including cleaning threads and using new gaskets.
Describes allowed methods for tightening screws, including torque spanner and pneumatic wrench usage.
Guidance on tightening flange connections crosswise in multiple steps.
Torque values for metric screws used in screwed connections.
Torque specifications for metric screws on shut-off valves and counter flanges.
Tightening torques for various threaded plugs without gaskets.
Torque values for screwed connections using aluminium gaskets, including screws, plugs, and nipples.
Tightening torques for sight glasses fitted with a sealing flange.
Torque specifications for sight glasses attached with a union nut.
Instructions for tightening screwed connections on terminal plates for FI current bars.
Torque values for securing the nuts of solenoid coils.
Tightening torque for the pressure relief valve (3/4-14 NPTF).
Torque specification for the SPI sensor thread (60 Nm) and mounting advice.
Torque for connecting flange of FI cooling plate with CSV, applicable for three-screw fixing.
Tightening torques for set screws used in shaft seals.
Torque values for locking screws on grooved nuts, varying by compressor design.
Torque specifications for fixing the electrical motor rotor to the male rotor shaft.
Torque for thread at piston rod and fixing at piston or piston rod.
