3-2-2 Using Single Battery Cradle (Optional)
1) Connect the power cord ② to the battery
charger ①.
2) Connect the battery charger ① to the
power connector of the single battery
cradle ③.
3) Plug the power cord ② into an electrical
outlet.
4) Insert the battery ④ into the single
battery cradle ③ until snaps in place.
3-2-3 Using Vehicle Charger (Optional)
1) Turn off the power to the printer.
2) Connect the vehicle charger ① to your
car’s cigarette lighter jack.
3) Open the external interface protection
cap in the direction of ②.
4) Connect the vehicle charger to the power
connector.
The printer may be seriously damaged if a
battery charger not provided by BIXOLON is
used. BIXOLON is not liable for such damage.
WARNING
Turn off the power before charging the battery
for the printer.
To Next Page
Loading...
