BIXOLON SPP-R210 - Quad Charger Battery Charging

Rev. 1.00
- 15 -
SPP-R210
3-2-4-2 Charging Battery (Printer)
1) Using the battery hooks, insert the
batteries into the Quad Battery
Charger as shown.
2) Push the battery in until you hear
snap.
3) Charging begins as soon as the
battery is completely inserted.
Batteries are charged to 8.4VDC,
0.8A.
4) Lift the hook and pull up to remove the
battery.
NOTE
Battery charging status descriptions are as follows.
LED
Charge Status
Charge Time
Red LED On
Charging
2.5 hours
Green LED Blinking
Over 80% Charged
Green LED On
Fully Charged
Red LED Blinking
Error Replace
or Reinstall Battery
CAUTION
1. If the red lamp of the charger blinks, install the battery again.
2. If the red lamp continues to blink despite several attempts (4 ~ 5 times) to
install the battery, contact your local dealer.
3. The charging time may vary depending on the type of the charger or ambient temperature.