4-1-5 Bluetooth configuration
Supported Model
- SRP-350IIOBE, SRP-350plusIII/352plusIII, SRP-F310II/F312II/F313II, SRP-380/382,
SRP-S300, SRP-Q300/Q302
Bluetooth setting can be changed by Bluetooth Configuration Tab.
In case of Serial(Bluetooth) communication, it is not able to check Bluetooth configuration.
■ Authentication & Encryption
Sets or cancels Authentication & Encryption mode when connecting via Bluetooth
* If Authentication & Encryption mode is disabled, connection to a device can be done
without a PIN Code.
■ Connection Mode
Sets Mode1, Mode2, or Mode3 when connecting via Bluetooth.
- Mode1: connection possible only with the first device with which connection succeeds
- Mode2: connection with all Bluetooth enabled devices possible via use of a PIN Code
- Mode3: connection possible only with the first device with which connection succeeds
and searching or use of connected device possible
■ PIN Code
Changes the PIN Code required for Bluetooth connections.
(maximum 12 characters long)
■ Device Name
Changes the device name produced when establishing a Bluetooth connection.
(maximum 12 characters long)
■ MFi Information
In case of iOS mode, MFi information will be displayed.
■ Auto Reconnection
Retry setting on Bluetooth can be enabled when Bluetooth connection is released.
To Next Page
Loading...
Need help?
General
