◈ Information
This Installation Guide includes a brief outline of information necessary
for product installation. For more detailed installation information,
please refer to the user manual in the enclosed CD. The contents of the
CD include the following.
1. Manual: User Manual, Code Chart, Control Commands
2. Drivers: Windows Drivers, OPOS Drivers
3. Utilities: a logo download tool
◈ Components
Cable
Paper Roll
Procuct Installation CDProcuct Installation CD
CD
STP-103
(STP-103DK)
AC/DC Adaptor
Power cord
Installation
Guide
◈ Connecting the cables
1. Turn off the printer and the host ECR (host computer).
2. Plug the power cord into the Adaptor, and then plug the Adaptor into
the power connector of the printer.
3. Plug the cable into the interface connector.
※ Note: Use the STP-103 exclusive interface cable only.
◈ Using the Operation Panel
POWER ERROR FEED ON LINE
• POWER (LED, GREEN)
When turning on the power, a green LED will be lit.
• ERROR (LED, RED)
When the paper is running low, a red LED blinks.
• FEED (Button)
Press the FEED button once to discharge extra paper. Holding down the
FEED button will discharge paper continuously until the button is
released. The FEED button can be used when the ON-LINE button is
turned off.
• ON LINE (Button)
To use the FEED button, first press the ON-LINE button once.
◈ Installing the Paper Roll
1. Insert a new paper roll, making
sure to align it properly.
2. Pull out a small amount of
paper, and close the cover.
◈ Setting the DIP switches
Changing Dip Switch settings must be done when the printer is off.
Any changes done while the printer is on will not be processed.
Transmission
Speed
Switch 1 Switch 2 Switch 3 Default
2400 ON OFF OFF
4800 OFF ON OFF
9600 OFF OFF ON
19200 ON OFF ON
38400 ON ON OFF
57600 OFF ON ON
115200 ON ON ON
9600
SW Function On Off Default
Switch 4 Print Density Bold Normal OFF
Switch 5 Handshaking Xon/Xoff RTS/CTS OFF
Switch 8
Firmware
Download
Download Print OFF
Switch 7
(Language)
Switch 6 (CPL Selction) Default
ON 24
ON English
OFF 32
ON Combination type
OFF Korean
OFF Completion type
*Korean:
Completion type
*English: 32 CPL
◈ Self-Test
1. Make sure the paper roll has been installed properly.
2. Turn on the power while holding down the FEED button. The self-
test begins.
3. The self-test prints the current printer status, providing the control
ROM version and the DIP switch setting.
4. After printing the current printer status, self-test printing will print the
following, and pause. (The PAPER LED light blinks.)
Self-test printing.
Please press the FEED button
5. Press the FEED button to continue printing. The printer prints a
pattern using the built-in character set.
6. The self-test automatically ends and cuts the paper after printing the
following.
*** COMPLETED ***
7. After the self-test is complete, the printer returns to normal on-line
status.
※ Note
The self-test lets you know if your printer is operating properly. It
checks the print quality, ROM version, and DIP switch settings.
Printer Installation Guide
KN04-00020A (Rev.1.3)
THERMAL PRINTER STP-103
Power cord
Interface cable
(Serial/Parallel)
AC Adaptor
Power connector
Interface
connector
STP※ -103DK exclusive cable
To Next Page
Need help?
General
Weight and Dimensions
