BIXOLON XT Series - Page 31

Network Connection Manual
Ver.2.01
- 31 -
Check the SMTP setting values
SMTP User ID
Check the ID registered to the mail server
SMTP Password
Enter the password for the corresponding User ID
SMTP Server
Name
Enter the mail server(Example: Domain or mail server IP)
* Check DNS settings when entering domain
SMTP Port
Number
Enter SMTP port
Default value of the SMTP Port is 25
From Address
Enter the e-mail address to be shown at the mail receiver
To Address
Enter the e-mail address to receive
Check Interval
Enter the period to check the printer status
Entered value will be effective in second unit
Paper Empty
ON – E-mail is sent out when there is no paper
OFF – Paper empty status is not checked
Cover Open
ON – E-mail is sent out when the printer cover is open
OFF – Printer cover status is not checked
Cutter Error
ON – E-mail is sent out when there is error in the auto cutter
OFF – Auto cutter error is not checked
Near End
ON – E-mail is sent out when the printer is almost out of paper
OFF – Paper remaining status is not checked
Ribbon
ON – E-mail is sent out when there is no ribbon
OFF – Paper empty status is not checked
Calibration Error
ON – E-mail is sent out when calibration is failed
OFF – Doesn’t check auto paper setting errors
TPH Over Heat
ON – Check TPH when overheated
OFF – Doesn’t check TPH overheat
Paper Jam
ON – E-mail is sent out when paper is jammed
OFF – Doesn’t check paper jam