Machine and operating elements Operating instructions VS12D /C /-R /-V /-
V/R
5 - 10 6.083.98.5.10.10 en
5
5.8 Paper holder
The paper holder is used when the sliced product has to be delivered straight on to paper
or foil.
Positioning of several sheets of paper or film:
Fig. 14: Paper holder
Using your thumb, press lever to the
right against spring pressure until it
clicks into place.
Push the stack underneath the open
holder.
Release the lever by pressing the top of
it lightly out of the locked position.
Removing of deposited portions and paper:
Using your thumb, press lever slightly to the right; at the same time pull top-most
piece of paper with portion under the open holders.
Release lever.
5.9 Round platter (optional)
This machine is fitted with an additional
guide shaft for installing the round platter.
For quick and easy handling, the round plat-
ter is attached to the guide shaft by a mag-
net lock.
During slicing, the turning of the round plat-
ter is depending on the number of slices.
Circular pattern depositing of rectangular
products is only possible by using the round
platter.
Fig. 15: Round platter
To Next Page
Loading...
Need help?
General
