BK Precision 1698 - Page 40

Command Sets BK models 1696/1697/1698
BLUE – Input Command RED – Return Data from Power
Supply
PS = Power Supply
Command Code
Description
SESS <address> <CR> [OK] [CR]
Disable front panel keypad
and make PS to Remote
Mode
ENDS <address> <CR> [OK] [CR]
Enable front panel keypad
and make PS to exit Remote
Mode
CCOM <address> <RS> {000-255} <CR> [OK] [CR]
Change RS-232/RS485
<RS> = 0 -> RS-232 <RS>
= 1 -> RS-485
GCOM <address> <CR> [RS] RS485 Address [###] [CR] [OK] [CR]
Get the RS-485 address
GMAX <address> <CR> Voltage [???] Current [???] [CR] [OK] [CR]
Get maximum voltage and
current of PS
GOVP <address> <CR> Voltage [???] [CR] [OK] [CR]
Get Upper Voltage Limit of
PS
GETD <address> <CR> Voltage [????] Current [????] [0] [CR] [OK] [CR]
Voltage [????] Current [????] [1] [CR] [OK] [CR]
Get Voltage & Current
reading from PS PS in CV
mode PS in CC mode
GETS <address> <CR> Voltage [???] Current [???] [CR] [OK] [CR]
Get Voltage & Current Set
Value from PS