BK Precision KNG Series User Manual

KNG MOBILE RADIO INSTALLATION GUIDE
1 INTRODUCTION
This document provides guidelines for the installation of BK Radio’s KNG
Mobile radios. Failure to adhere to these guidelines may result in diminished
performance or physical damage to the radio. Installations should only be
performed by RELM authorized dealers or technicians.
2 GENERAL
Plan your installation carefully. Locate the radio and microphone within easy
reach, giving the operator a clear view of the display.
When selecting a mounting position for your KNG Mobile, look for a fl at surface
that will provide adequate space for the radio and cable attachments. For dash
mount installation clearance of at least 12” x 7 1/2” is recommended.
Do not locate the radio, microphone or speaker in a position that interferes with
safe operation of the vehicle or equipment.
It is recommended to run all necessary cables or wires prior to installation of a
radio or remote control head.
RECOMMENDED INSTALLATION ORDER
Prepare and route power cable assembly1.
Connect Ignition sense (if used)2.
Install Antenna(s) and route cable3.
Install remote speaker(s) and route speaker wire4.
Route any connections to be made to the radio or remote accessory 5.
connector(s)
Install remote control head (if used)6.
Install dash mount/radio core7.
3 REQUIRED EQUIPMENT
Small fl at blade screw driver.•
Wire crimper or pliers•
KAA0630 KNG Dash mount installation kit•
ADDITIONAL EQUIPMENT
KAA0638 KNG Remote mount installation kit•
KAA0635, KAA0636 or KAA0637 Remote mount cable assembly•

BK Precision KNG Series Specifications

General

Battery Type	Li-Ion
IP Rating	IP67
Input Impedance	50 Ω
Input VSWR	1.5:1
Third Order Intercept	+25 dBm
Display	LCD

Summary

1 INTRODUCTION

2 GENERAL

3 REQUIRED EQUIPMENT

4 HARDWARE MOUNTING

4.1 WIRING

Instructions for connecting power and ignition sense lines to the radio system, including safety notes.

4.2 SPEAKER INSTALLATION

Guidance on selecting locations, drilling, and connecting external speakers for the KNG Mobile radio.

4.3 DASH-MOUNT/RADIO CORE INSTALLATION

Steps for mounting the KNG mobile radio core in a dash configuration, including hole patterns.

4.4 REMOTE-MOUNT CONTROL HEAD INSTALLATION

Procedure for installing a KNG remote control head, requiring specific kits and cable assemblies.

4.5 MICROPHONE MOUNTING

Details on mounting the microphone hanger clip and connecting the microphone to the radio.

4.6 ANTENNA INSTALLATION

Guidelines for installing a 50-ohm antenna, ensuring proper frequency range and handling output power.

4.7 KAA0661 COVER INSTALLATION AND REMOVAL

Instructions for installing and removing the KAA0661 display cover from the KNG mobile radio.

4.8 INSTALLATION ACCESSORIES

List of part numbers and descriptions for various installation accessories for the KNG mobile radio.