BK Radio GPH-CMD User Manual

16 BK Radio
When the PTT switch is released, the radio
continues to monitor the selected channel for
the preset scan delay time before it resumes
scanning.
TALKBACK SCAN
If your radio is programmed for Talkback
Scan, press PTT while a channel is active or
while scan delay time remains. You will be
responding on the transmit frequency of the
received channel.
Talkback Scan will not work if Priority Scan is
also on and your radio is programmed to
always transmit on the Priority 1 channel.
CHANGE THE SCAN LIST
If the radio has not been programmed for
Scan List Lock, the user may add or remove
channels from the Scan List. If user changes
are enabled, follow these steps to change the
Scan List:
1. Slide Switches B (scan) and C (priority)
down.
2. Select a channel to be added or removed
from the Scan List by turning the Channel
Selector knob. If the channel is already on
the Scan List, SCN appears in the display.
3. Press the [ENT] key to add a channel to
the Scan List. A short beep sounds and
SCN appears in the display.
4. Press the [CLR] key to remove a channel
from the Scan List. A short beep sounds
and SCN disappears from the display.
GROUP SCAN
Channels on each “Channel Scan List” in
groups on the “Group Scan List” are scanned
sequentially. The selected group is always
scanned when Group Scan is enabled, even if
that group is not on the Group Scan List.
SCN
LABEL 12
1
2
3
4
5
6
7
8
9
0
*
#
CLR
FCN
PRI
ENT
GPH-CMD Owner’s Manual 21
NOTE: If the radio is programmed for Dual
Priority operation, only the Priority 1
channel can be changed with the
[PRI] key.
NOTE: A channel can be the priority
channel even if it is on the Scan
List. Due to multiple sampling of the
same channel, however, maximum
performance occurs when the
priority channels are not on the
Scan List.
USER TRANSMIT CODE GUARD
When the radio is being programmed with transmit and receive
frequencies for each channel, a receive Code Guard value and a
transmit Code Guard value can also be assigned to each channel. On
channels that do not have a default transmit Code Guard programmed,
the user can choose CxCSSs from a global UTXG Pick List containing
32 entries. To assign a UTXG for use on a channel, all scanning
functions (Channel Scan, Group Scan, and Priority Scan) must be
turned OFF.
The user selects a channel and then uses the
keypad to enter a number from 1 to 32. When
UTXG is active, the second line of the display
will show the number of the selected list entry
(TONE – XX). Once a UTXG is assigned to a
particular channel, it will be stored and used
with that channel whenever the channel is
selected. Repeater Talk Around operation will
use the pre-programmed RX CxCSS.
The UTXG Pick List can be viewed by pressing
[FCN] [1]. The display will show:
TONE – 01 or TONE – 01
XXX.X DXXX
Press [PRI] to increment through the list or key
in a number. Press [ENT] to exit the list
viewer. (This feature is for viewing the list only.
Pressing [ENT] when a list item is displayed
does NOT associate the UTXG with the
selected channel.)
TONE - 01
000.00
1
2
3
4
5
6
7
8
9
0
*
#
CLR
FCN
PRI
ENT
LABEL 20
TONE 8

BK Radio GPH-CMD Specifications

General

Brand	BK Radio
Model	GPH-CMD
Category	Portable Radio
Language	English