12
ENGLISH
(Original instructions)
Troubleshooting Guide
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
Problem Possible Cause Possible Solution
Unit will not start. Battery pack not installed properly.
Battery pack not charged.
Internal componets too hot.
Brushes worn out.
Check battery pack installation.
Check battery pack charging
requirements.
Allow tool to cool down.
Have brushes replaced by an
authorized BLACK+DECKER service
center.
Battery pack will not charge. Battery pack not inserted into
charger.
Charger not plugged in.
Surrounding air temperature too hot
or too cold.
Insert battery pack into charger until
LED illuminates.
Plug charger into a working outlet.
Refer to "Important charging notes" for
more details.
Move charger and battery pack to a
surrounding air temperature of above
40 degrees F (4,5°C) or below 105
degrees F (+40,5°C).
Unit shuts off abruptly. Battery pack has reached its
maximum thermal limit.
Out of charge. (To maximize the life
of the battery pack it is designed to
shut off abruptly when the charge is
depleted.)
Allow battery pack to cool down.
Place on charger and allow to
charge.
To Next Page
Loading...
Need help?
General
