Black & Decker BDXBTAGVAR

Questions and Answers

M
Mr. Daniel Ward DDSAug 5, 2025
Why is my Black & Decker BDXBTAGVAR failing?
- D
  david19Aug 5, 2025
  If your Black & Decker Water Pump is failing, there are several potential causes. It could be due to an air leak, indicating too much air in the system, so check the suction piping and valve glands on any suction gate valves. Another possibility is insufficient water; ensure the water level is adequate and that the skimmer isn't drawing air. The pump strainer gasket might be clogged, in which case you should clean the pump strainer pot. Finally, the pump strainer gasket itself could be defective and require replacement.
A
Alan HuertaAug 9, 2025
What to do if my Black & Decker BDXBTAGVAR fails to start?
- B
  Beth CookAug 10, 2025
  If your Black & Decker Water Pump isn't starting, the issue could stem from several factors. First, check if the mains voltage is present and replace the fuse or reset the breaker/GFCI if necessary. Another potential cause is a locked pump shaft; inspect whether the pump can be rotated by hand and remove any blockage. If the pump shaft is damaged, it might require a pump replacement.
T
Tracey WilliamsAug 15, 2025
Why does my Black & Decker BDXBTAGVAR Water Pump have reduced capacity?
- A
  Amanda StewartAug 15, 2025
  Reduced capacity or head in your Black & Decker Water Pump can arise from a few reasons. You might have air pockets or leaks in the suction line, so check the suction piping and valve glands on any suction gate valves. A clogged impeller could also be the culprit; disassemble the pump and clean any debris from the impeller. Lastly, a clogged pump strainer can cause this issue, so clean the suction trap.
J
jondavisAug 19, 2025
How to fix a Black & Decker BDXBTAGVAR Water Pump that runs without flow?
- J
  Jonathan HickmanAug 20, 2025
  If your Black & Decker Water Pump is running but not producing flow, there are a few things to investigate. The impeller might be loose; check if the pump is spinning by looking at the fan on the back of the Variable Speed Pump and ensure the pump impeller is correctly installed. An air leak could also be the cause, so check the plumbing connections and verify they are tight. Finally, there might be clogged or restricted plumbing; check for blockage in the strainer or suction side piping.
J
Jennifer PatelAug 25, 2025
Why is my Black & Decker BDXBTAGVAR Water Pump so noisy?
- K
  Kelly GibsonAug 26, 2025
  A noisy Black & Decker Water Pump can be caused by several factors. Debris might be in contact with the fan, so check that the back of the pump is free from dirt and debris. Another possibility is debris in the strainer basket, which requires cleaning. Lastly, loose mounting can cause noise, so check that the mounting bolts of the pump are tight.
K
Kimberly BakerAug 30, 2025
What to do if Black & Decker BDXBTAGVAR runs then stops?
- U
  uphillipsAug 30, 2025
  If your Black & Decker Water Pump runs and then stops, it could be due to an over temperature FAULT. Check that the back of the pump is free from dirt and debris. Alternatively, it could be an over current FAULT, in which case you should use compressed air to clean it.