Black & Decker BXUP750XCE

Questions and Answers

C
Curtis ScottJul 30, 2025
What to do if my Black & Decker BXUP750XCE motor is running but not pumping water?
- D
  Deanna ParsonsJul 30, 2025
  If your Black & Decker Water Pump isn't pumping water even though the motor is running, the suction strainer (A1) may be blocked, so you should clean it. Alternatively, the check valve (if installed) might be jammed, in which case you should clean or replace it. Another possible cause is an air bubble in the pump body (A4); try tilting the appliance under water to let the air escape.
N
Nicole FordAug 4, 2025
Why is my Black & Decker BXUP750XCE not pumping water and the motor is not running?
- K
  Kimberly BennettAug 4, 2025
  If your Black & Decker Water Pump is not pumping water and the motor isn't running, it could be due to several reasons. First, ensure that mains power is present and that the plug (A12) is firmly connected, as the mains voltage might be too low or the plug may not be properly connected. Next, check if the residual current device has tripped and reset it. If it trips again, consult an electrician. Also, the impeller might be jammed, so try to free it from any obstructions. If none of these solutions work, the motor or capacitor may be damaged, and you should notify the dealer.
G
Gabriela VargasAug 10, 2025
How to fix a Black & Decker BXUP750XCE that only delivers a small amount of water?
- A
  Ashley McdonaldAug 10, 2025
  If your Black & Decker Water Pump is only delivering a small amount of water, start by cleaning the suction strainer (A1) as it may be partially blocked. Also, check the hose for any obstructions and remove them. Ensure that you are using hoses of at least ø25 mm (1”), as a delivery hose that's too small can restrict water flow. Finally, remember that excessive head will reduce the flow rate, so consider the height of the water discharge point in relation to the appliance.
C
Cynthia DavisAug 17, 2025
Why is my Black & Decker Water Pump experiencing uneven operation?
- B
  Benjamin HallAug 17, 2025
  Uneven operation of your Black & Decker Water Pump can be caused by several factors. Check for solids obstructing the free rotation of the impeller and remove any dirt. Ensure that the liquid temperature does not exceed 35°C, as liquid that is too hot can cause issues. Verify that the electrical voltage is within the tolerance range stated on the nameplate by connecting the appliance to a suitable electrical system. If none of these steps resolve the issue, the motor may be faulty, and you should notify the dealer.
J
John CrossAug 23, 2025
What to do if water is leaking from the pump body (A4) of my Black & Decker BXUP750XCE Water Pump?
- M
  Matthew FischerAug 23, 2025
  No action is needed. Water leaks from the bleeder hole (A7) between the top and bottom parts because the bleeder hole is a technical necessity.