8
ENGLISH
(Original instructions)
Safety instructions
IMPORTANT SAFETY INSTRUCTIONS
@
WARNING: When using this pressure washer,
basic safety precautions should always be followed
including the following:
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
This machine is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge.
Children should be supervised to ensure that they do not
play with the appliance.
Read all the instructions before using the product.
To reduce the risk of injury, close supervision is necessary
when a product is used near children.
Know how to stop the product and bleed pressures
quickly. Be thoroughly familiar with the controls.
Stay alert – watch what you are doing.
Do not operate the product when fatigued or under the
inuence of alcohol or drugs.
Keep operating area clear of all persons and animals.
Do not overreach or stand on unstable support. Keep
good footing and balance at all times.
Follow the maintenance instructions specied in
the manual.
The electric supply connection shall be made by a
qualied electrician and comply with IEC 60364-1. It is
recommended that the electric supply to this machine
should include either a residual current device that will
interrupt the supply if the leakage current to earth exceeds
30 mA for 30 ms or a device that will prove the earth
circuit.
@
WARNING: Risk of injection or injury – do not direct
discharge stream at persons or animals.
@
WARNING: Read this entire manual before
attempting to assemble, operate or install the
product.
@
WARNING: This unit was designed for specic
applications. It should not be modied and/or used for
any application other than that which it was designed.
NOTICE: Always store your pressure washer in a
location where the temperature will not fall below
40 °F (4 °C). freeze damage is not covered by the
warranty.
1 . Do not touch plug or outlet with wet hands.
2 . Avoid accidental starts. Move switch on unit to OFF
position before connecting or disconnecting cord
to electrical outlets.
3 . Water spray must never be directed towards any
electric wiring or directly towards the pressure
washer machine itself or fatal electric shock
may occur.
4 . Never carry your pressure washer by the cord. Do not
pull on the cord to disconnect from the outlet.
5 . To prevent damage, the cord should not be
crushed, placed next to sharp objects or near a
heat source.
6 . Check power cords before using. Damaged cords can
reduce performance of pressure washer or cause a
fatal electrical shock
7 . The narrow pin point stream is very powerful. It is
not recommended for use on painted surfaces,
wood surfaces or items attached with an
adhesive backing.
8 . Keep operating area clear of all persons
and animals.
9 . Always use both hands when operating pressure
washer to maintain complete control of the wand.
10 . Do not touch nozzle or water spray while operating.
Never place hands in front of nozzle.
11 . Wear safety goggles while operating. Wear
protective clothing and footwear to protect
against accidental spraying.
12 . Disconnect power plug from the outlet when
not in use and prior to the detaching of the high
pressure hose.
13 . Never tie knots or kink the high pressure hose as
damage could result. Inspect the high‑pressure
hose regularly. Replace the hose immediately if
it is damaged, worn or shows any signs of cracks,
bubbles, pinholes, or other leakage. Never grasp a
high‑pressure hose that is leaking or damaged.
14 . Do not operate or store this product in temperatures
below 40°F (4°C). Freeze damage is not covered by
the warranty.
15 . Carefully observe all chemical instructions and
warnings before using. Use only approved pressure
washer cleaners. Do not use bleach, chlorine,
or any cleaners containing acids. Always follow
manufacturer’s label recommendations for proper
use of cleaners. Always protect eyes, skin and
respiratory system from cleaners.
16 . The pressure washer should not be used in areas where
gas vapors may be present. An electric spark could
cause an explosion or fire.
17 . To minimize the amount of water getting
into the pressure washer, the unit should be
placed as far as possible from the cleaning site
during operation.
To Next Page
Loading...
Need help?
General
