EasyManua.ls Logo

Black & Decker BPACT10WT - Remote Control and Water Drainage

Black & Decker BPACT10WT
78 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 15
SET UP & USE
OPERATING FROM THE REMOTE CONTROL
BATTERY INSTALLATION (BATTERIES NOT INCLUDED)
(1) Slide open the battery compartment cover.
(2) Insert 2 × “AAA” batteries as shown.
(3) Slide back the battery cover.
CAUTION: Use only AAA or IEC R03 1.5V alkaline batteries. Remove the batteries
if the remote is not used for a month or longer. Do not attempt to recharge the
batteries. Both batteries should be replaced at the same time. Do not dispose of
the batteries in a fire as they may explode.
Point the remote control at the receiver on the appliance. The remote control must
be no more than 7 meters away from the appliance (without obstacle between the
remote control and the receiver).
The remote control must be handled with extreme care. Do not drop it or
expose it to direct sunlight or sources of heat.
23 Feet

Table of Contents

Related product manuals