What to do if my Black & Decker PI800BB Inverter is in thermal shutdown condition?
If your Black & Decker Inverter is in thermal shutdown, allow it to cool down. Make sure there is enough ventilation around it and that the load is no more than 800 watts for continuous operation.
What to do if the equipment being operated draws too much power from my Black & Decker PI800BB Inverter?
If the equipment you're operating is drawing too much power, reduce the load to a maximum of 800 watts.
What to do if my Black & Decker PI800BB has low input voltage?
If your Black & Decker Inverter has low input voltage, start the engine.
Why does my Black & Decker PI800BB Inverter make a buzzing sound in audio systems?
A buzzing sound in audio systems connected to the Black & Decker Inverter may occur if the power supply in the electronic device does not properly filter the modified sine wave produced by the inverter. Use a sound system that has a higher quality power supply.
What to do if my Black & Decker PI800BB's battery voltage is below 10.5 volts?
If the battery voltage of your Black & Decker Inverter is below 10.5 volts, recharge the battery or check the DC power supply.
What to do if my Black & Decker Inverter is overloaded?
If the equipment connected to your Black & Decker Inverter is drawing too much power, reduce the load to a maximum of 800 watts.
How to stop TV interference from Black & Decker Inverter?
If you are experiencing television interference when using your Black & Decker Inverter: * Move the Inverter as far away as possible from the TV set, the antenna, and the antenna cables. Use a short AC extension cord, if necessary. * Adjust the orientation of the antenna cables and the TV power cord to minimize interference. * Ensure that the antenna feeding the TV provides an adequate (snow-free) signal and that high-quality, shielded antenna cable is used.
What to do if AC output is shorted in Black & Decker PI800BB?
If the AC output of your Black & Decker Inverter is shorted, unplug the AC appliance, disconnect the unit from any 12 volt DC power source, and check the appliance cord. Refer to the Service Information section that follows.
Why is my Black & Decker PI800BB Inverter causing a buzzing sound in audio systems?
If you hear a buzzing sound in your audio systems when using the Black & Decker Inverter, it may be because the power supply in the electronic device does not properly filter the modified sine wave produced by the inverter. Try using a sound system that has a higher quality power supply.
What to do if the Black & Decker PI800BB Inverter has low input voltage?
If the input voltage to your Black & Decker Inverter is low, start the engine.
General| Brand | Black & Decker |
|---|---|
| Model | PI800BB |
| Category | Inverter |
| Language | English |
Covers general safety, risk of unsafe operation, important instructions, and specific warnings.
Provides an introduction to the inverter and lists its key features.
Details the location and function of power button, LEDs, battery clips, and outlets.
Explains the DC to AC conversion process and the modified sine wave output.
Instructions for connecting the inverter to a 12V DC power source using battery clips or hardwiring.
Guidance on connecting equipment, rated vs. actual current draw, and inductive loads.
Steps for using AC outlets, inverter protective features, and operating tips for optimal use.
Instructions for proper storage and user-replaceable fuse replacement.
Solutions for audio buzzing, TV interference, and interpretation of fault LED indicators.
Details the one-year limited warranty and key technical specifications of the inverter.
To Next Page
