3 CONFIGURE Commands of CLI
Table : CONFIGURE Commands
Command Function
terminal Configure from the terminal
access-list Access list
aggregation Aggregation mode
clock Configure time-of-day clock
do Run exec commands in config mode
end Go back to EXEC mode
exit Exit from Configuration mode
interface Select an interface to configure
ip Internet Protocol
ipmc IPv4/IPv6 multicast configuration
lacp LACP settings
lldp LLDP configurations.
logging Syslog
loop-protect Loop protection configuration
mac MAC table entries/configuration
monitor Set monitor configuration.
no Negate a command or set its defaults
ntp Configure NTP
qos Quality of Service
spanning-tree Spanning Tree protocol
To Next Page
Loading...
