Black Hawk FS Future - Mounting the Main Unit; Mounting the Search Coil

Assembly 19
4.1 Mounting the Main Unit
When the main unit is mounted to the telescopic rod it looks like that in illustration 4.5.
4.2 Mounting the Search Coil
Assembling the search coils to the telescopic rod is very simple. Unscrew the nylon bolt, be sure the
rubber washers are seated next to the shaft. Insert the end of the shaft onto the coil, insert the bolt and
tighten. Finger tight only so that the coil does not move. Make note that on the end of the telescopic rod
there is a nylon bolt with 2 rubber washers, these are important to keep the coil firmly in place.
Illustration 4.4: Shows the control unit ready
to mount to bracket
Illustration 4.5: Control unit mounted to
bracket
Coil Connector
Illustration 4.6: Telescopic Rod end
Illustration 4.7: Search Coil mounted to
Telescopic Rod
Orient Detectors
www.orientdetectors.com