ENGLISH • 23
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Unit will not start.
Battery pack not installed properly. Check battery pack installation.
Battery pack not charged.
Check battery pack charging
requirements.
Battery pack will not charge.
Battery pack not inserted into charger.
Insert battery pack into charger until
green LED appears.
Charger not plugged in.
Plug charger into a working outlet.
Refer to “Important Charging
Notes” for more details.
Surrounding air temperature too hot or
too cold.
Move charger and battery pack to a
surrounding air temperature of above
40 degrees F (4.5°C) or below 105
degrees F (+40.5°C).
AUTOSENSE Technology
doesn’t work or stops
prematurely.
Tool in drill mode
Ensure tool is in screwdriver mode
as described in “Drill / Drive Mode
Select.”
Not enough pressure when driving.
Try again and apply a substantial
amount of pressure to the back of
the tool.
AUTOSENSE Technology disengaged.
Release the trigger and depress it
again to reactivate the AUTOSENSE
technology.
Unit shuts off abruptly.
Battery pack has reached its maximum
thermal limit.
Allow battery pack to cool down
Out of charge. ( To maximize the life of
the battery pack it is designed to shutoff
abruptly when the charge is depleted.)
Place on charger and allow to
charge.
SERVICE INFORMATION
BLACK+DECKER offers a full network of company-owned and authorized service locations. All BLACK+DECKER
Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service.
For more information about our authorized service centers and if you need technical advice, repair, or genuine factory
replacement parts, contact the BLACK+DECKER location nearest you, or visit us at www.BlackandDecker-la.com
To Next Page
Loading...
