Black+Decker BDINF12 User Manual

ENGLISH
3
will draw. An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating. The
following table shows the correct size to use depending on
cord length and nameplate ampere rating. If in doubt, use
the next heavier gauge. The smaller the gauge number,
the heavier thecord.
Minimum Gauge for Cord Sets
Volts Total Length of Cord in Feet
120V 0-25 26-50 51-100 101-150
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
Ampere Rating
More Not more American Wire Gauge
Than Than
0 - 6 18 16 16 14
6 - 10 18 16 14 12
• OUTDOOR USE EXTENSION CORDS. When tool is
used outdoors, use only extension cords intended for use
outdoors and somarked.
• STAY ALERT. Watch what you are doing.Use common
sense.Do not operate tool when you aretired.
• CHECK DAMAGED PARTS. Before further use of the
tool, a guard or other part that is damaged should be
carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment
of moving parts, binding of moving parts, breakage of
parts, mounting, and any other conditions that may
affect its operation. A guard or other part that is damaged
should be properly repaired or replaced by an authorized
service center unless otherwise indicated elsewhere in this
instruction manual. Have defective switches replaced by
authorized service center. Do not use tool if switch does
not turn it on andoff.
• DO NOT OPERATE portable electric tools near flammable
liquids or in gaseous or explosive atmospheres. Motors in
these tools normally spark, and the sparks might ignitefumes.
ADDITIONAL SAFETY WARNINGS FOR YOUR
INFLATOR

WARNING: FOR HOME AND CAR USE ONLY:
• Inflate bike tires, balls, rafts, swimming pool floats,
air mattresses, and more in and around the home.
Recommended maximum continuous duty at 65 psi is 2
minutes on with 5 minutesoff.

WARNING: RISK TOBREATHING.
• The compressed air from your inflator is not safe for
breathing. Never inhale air from your inflator or from a
breathing device connected to theinflator.

WARNING: RISK OFBURSTING.
• Too much air pressure causes a hazardous risk of bursting.
Check the manufacturer’s maximum pressure rating for
objects beinginflated.
• Do not leave inflator running unattended. It could burst
tires or other items.
• Use a tire gauge to check the tires pressure before each use
and while inflating tires; see the tire sidewall for the correct
tirepressure.

WARNING: RISK OF UNSAFEOPERATION.
• Do not modify or attempt to repair. Never drill into,
weld, or make any modifications to the inflator or its
attachments.
• Operate only with the accessories included or air handling
parts acceptable for not less than 160 psi. The use of any
accessory not recommended for use with this tool could
behazardous.
• Never “horseplay.” High pressure air is dangerous. Don’t
direct air-flow at yourself orothers.

WARNING: Always leave the valve adaptor lever open
when not inuse.

WARNING: RISK OF FIRE:
• Inflator can become hot during use. Allow inflator to cool
30 minutes before storingaway.
CALIFORNIA PROPOSITION 65

WARNING: This product or its power cord contains
lead, a chemical known to the State of California to
cause cancer and birth defects or other reproductive
harm. Wash hands after handling
LIQUID CRYSTAL DISPLAY FLUID
(FIRST AID MEASURES)
If liquid crystal comes in contact with your skin:
• Wash area off completely with plenty of water. Remove
contaminatedclothing.
If liquid crystal gets into your eye:
• Flush the affected eye with clean water and then seek
medicalattention.
If liquid crystal is swallowed:
• Flush your mouth thoroughly with water. Drink large
quantities of water and induce vomiting. Then seek
medicalattention.
The label on your tool may include the following symbols. The
symbols and their definitions are asfollows:
V ......................... volts
Hz .......................hertz
min ..................... minutes
or DC ......direct current
...................... Class I Construction
(grounded)
…/min ..............per minute
BPM ....................beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................watts
or AC ...........alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n
o
.......................no load speed
n .........................rated speed
......................earthing terminal
.....................safety alert symbol
.....................visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation

Black+Decker BDINF12 Specifications

General

Brand	Black+Decker
Model	BDINF12
Category	Power Tool
Language	English