Installing a Bit or Accessory into a Keyless Chuck (Fig. D)
WARNING: Do not attempt to tighten drill bits (or any other accessory) by gripping the front part of the chuck and
turning the tool on. Damage to the chuck and personal injury may result. Always lock off trigger switch and
disconnect tool from power source when changing accessories.
WARNING: Always ensure the bit is secure before starting the tool. A loose bit may eject from tool causing possible
personal injury
To insert a drill bit or other accessory, follow these steps.
1. Turn tool off and remove battery pack.
2. Grasp the black sleeve of the chuck with one hand and use the other hand to secure the tool. Rotate the sleeve
counterclockwise far enough to accept the desired accessory.
3. Insert the accessory about 3/4″ (19 mm) into the chuck 4 and tighten securely by grasping and rotating the
chuck sleeve clockwise with one hand while holding the tool with the other. When the chuck is nearly tightened
you will hear a clicking sound. After 12-14 clicks the chuck is securely tightened around the accessory. Your
tool is equipped with an automatic spindle lock mechanism. This allows you to open and close the chuck with
one hand.
Be sure to tighten chuck with one hand on the chuck sleeve and one hand holding the tool for maximum tightness. To
release the accessory, repeat steps 1 and 2 above.
OPERATION
WARNING: To reduce the risk of serious personal injury, turn unit off and remove the battery pack before making
any adjustments or removing/ installing attachments or accessories. An accidental start‑up can cause injury
Installing and Removing the Battery Pack (Fig. A)
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack 6 into the tool handle, align the battery pack with the rails inside the tool’s handle and slide
it into the handle until the battery pack is firmly seated in the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release button 5 and firmly pull the battery pack out of the
toolhandle. Insert it into the charger as described in the charger section of this manual
Proper Hand Position (Fig. A)
WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal injury, ALWAYS hold securely in anticipation of a sudden
reaction.
Trigger Switch/Reversing Button (Fig. A)
1. The drill is turned ON and OFF by pulling and releasing the trigger switch 1 .
2. A forward/reverse control button 2 determines the direction of the tool and also serves as a lock off button.
3. To select forward rotation, release the trigger switch and depress the forward/reverse control button to the left.
4. To select reverse, depress the forward/ reverse control button the opposite direction.
NOTE: The center position of the control button locks the tool in the off position. When changing the position of the
control button, be sure the trigger is released.
Mode Selection (Fig. A)
The mode selection collar 3 can be used to select the correct operating mode depending upon the planned
application.
To select, rotate the collar until the desired symbol aligns with the arrow.
To Next Page
Loading...
