or deflect the bit.
IF THE DRILL STALLS:
RELEASE TRIGGER SWITCH IMMEDIATELY, remove drill bit from work, and determine cause of stalling.
DO NOT DEPRESS TRIGGER SWITCH ON AND OFF IN AN ATTEMPT TO START A STALLED DRILL
— THIS CAN DAMAGE THE DRILL.
To minimize stalling or breaking through the material, reduce pressure on drill and ease the bit through the
last fractional part of the hole.
Large holes (5/16″ to 1/2″ [7.9 mm to 12.7 mm]) in steel can be made easier if a pilot hole (5/32″ to 3/16″ [4 mm
to 4.8 mm]) is drilled first.
If drilling thin material or material that is prone to splinter, use a wood “back-up” block to prevent damage to the
workpiece.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury, turn unit off and remove the battery pack before making
any adjustments or removing/ installing attachments or accessories. An accidental start‑up can cause injury
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once a week. To minimize the risk of eye
injury, always wear ANSI Z87.1 approved eye protection when performing this procedure.
WARNING: Never use solvents or other harsh chemicals for cleaning the non‑metallic parts of the tool. These
chemicals may weaken the plastic materials used in these parts. Use a cloth dampened only with water and mild
soap. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid
Accessories
WARNING: Since accessories, other than those offered by BLACK+DECKER, have not been tested with this
product, use of such accessories with this tool could be hazardous. To reduce the risk of injury, only
BLACK+DECKER recommended accessories should be used with this product.
Recommended accessories for use with your tool are available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any accessory, please contact BLACK+DECKER call 1-800-544-
6986 .
Repairs
The charger and battery pack are not serviceable. There are no serviceable parts inside the charger or battery pack.
WARNING: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (including brush
inspection and replacement, when applicable) should be performed by a BLACK+DECKER factory service center or
a BLACK+DECKER authorized service center. Always use identical replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
WARRANTY SERVICE: Registering your product will help you obtain more efficient warranty service in case
there is a problem with your product.
CONFIRMATION OF OWNERSHIP: In case of an insurance loss, such as fire, flood or theft, your registration
of ownership will serve as your proof of purchase.
FOR YOUR SAFETY: Registering your product will allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer Safety Act.
Register online at www.BlackandDecker.com/NewOwner
TWO-YEAR LIMITED WARRANTY
Black & Decker (U.S.) Inc. warranties this product to be free from defects in material or workmanship for a period of
two (2) years following the date of purchase, provided that the product is used in a home environment. This limited
To Next Page
Loading...
