What to do if my Blagdon Pump Water Pump discharges fluid from air exhaust?
If your Blagdon Pump Water Pump is discharging fluid from the air exhaust, it could be due to diaphragm failure or a loose frontplate. Replace the diaphragm. Also, re-torque the frontplate to the manual's specifications.
Why my Blagdon Pump Water Pump pump will not start?
If your Blagdon Pump Water Pump won't start, possible causes include: * Air valve assembly malfunction/seizure * Obstructed fluid line * Obstructed diaphragm chamber * Diaphragm failure causing fluid & excessive air to be expelled through the exhaust * Diaphragm seal failure * Air valve system malfunction * Air connected to exhaust. To resolve this: * Check the carrier for freedom of movement – clean, oil, and replace if necessary. * Clean the fluid line or increase its size. * Remove any obstruction in the diaphragm chamber. * Replace the diaphragm or shaft seals. * Check all seals in the valve chest assembly. * Reconnect the air inlet.
What to do if Blagdon Pump Water Pump strokes but will not discharge?
If your Blagdon Pump Water Pump strokes but doesn't discharge, it could be due to excessive suction lift, suction line leakage, a valve ball not seating correctly or being damaged, a clogged suction line or strainer, or diaphragm failure. * Shorten the suction line. * Check and correct any suction line leakage. * Inspect the valve ball, remove any obstruction, or replace it if damaged. * Clear any clogs in the suction line or strainer. * Replace the diaphragm.
Why does my Blagdon Pump B06 Water Pump have an intermittent stroke rate?
An intermittent stroke rate in your Blagdon Pump Water Pump could be caused by over-lubrication, diaphragm shaft seal failure, air valve system malfunction, or a valve ball not seating or being partially obstructed. Try these steps: * Shut down the pump. * Remove the air connection and introduce a small amount of de-greasing agent into the air valve, then replace the line. * Run the pump until it clears. * Replace the seals. * Check all seals in the valve chest assembly.
Why Blagdon Pump B06 has erratic flow?
Erratic flow in your Blagdon Pump Water Pump can be caused by diaphragm failure on one side, a valve ball not seating, suction leakage, diaphragm failure causing fluid and excessive air to be expelled through the exhaust, diaphragm seal failure, or air valve system malfunction. To address this: * Replace the diaphragm. * Check the valve ball and remove any obstruction. * Check and correct any suction leakage. * Replace the shaft seals. * Check all seals in the valve chest assembly.
Manufacturer contact details for support and inquiries.
Instructions and considerations for properly installing the pump.
Critical safety precautions and warnings for operating the pump.
Essential procedures for grounding the pump to prevent static discharge in hazardous environments.
Detailed steps for overhauling and maintaining the pneumatic air valve assembly.
Procedures for disassembling and servicing the liquid-handling parts of the pump.
Step-by-step guide for replacing the pump's diaphragms.
Specifications and considerations for pumps operating in high-temperature fluid applications.
General| Model | B06 |
|---|---|
| Cable Length | 10m |
| Voltage | 230V |
| Frequency | 50Hz |
| Max Head | 5.5 m |
| Max Flow Rate | 6000 l/h |
To Next Page
