- 16 -
• HOW TO DISPENSE STEAM
NOTE! if the sequence below does not work, see the
"TROUBLESHOOTING " section.
Warning! RISK OF BURN
The appliance generates steam and hot water at high tem-
perature! Never direct the steam or hot water jet towards
the body, handle the nozzle with care using the handle
protector (K7)
Do not touch the nozzle after use.
- Clean the nozzle with a cloth dampened with hot water.
- Make sure that the nozzle is inside the grid 12 (fig. 19).
- Open the steam knob 7 gradually and carefully and keep it
open until the hot water drops contained inside the nozzle
come out. (fig. 20)
- When only steam comes out, close the knob. Using the
anti-burn handle (K7 ), introduce the nozzle inside the liquid
to be heated and open the knob again after this operation.
This will avoid squirts.
- Use the knob 7 to adjust the steam as desired, while keeping
the nozzle inside the liquid.
- Once the liquid has been heated, close the steam knob 7
and remove the container with the heated liquid.
- With a cloth dampened with hot water, clean the nozzle,
place it inside the grid and open the steam knob to eject the
heated liquid from the nozzle.
The heating of the liquid has been completed.
fig.19
8
fig.20
To Next Page
Loading...