13
INSTALLATION
6) ELECTRICAL CONNECTION
The appliance is supplied with a 1800 mm long flexible supply lead.
The point of attachment for this lead is located at the rear and on the underside of the appliance
380 mm from the right hand side.
The voltage and power consumption are detailed on the underside of the appliance. Ensure that the
appliance is correctly rated to the supply.
Connect appliance by way of a switched power point.
THE APPLIANCE MUST BE EARTHED
Ensure that this power point is properly earthed. Look at the connection wiring diagrams
(fig. 8).
Warning: in order to avoid hazard, any electrical work performed on this equipment or its
associated wiring, should only be done by persons authorised by the supplier or similarly
qualified persons.
The socket outlet for this hotplate shall be installed near the hotplate and shall be easily
accessible.
CAUTION!
The manufacturer cannot be responsible for the missing earthing of the appliance.
Electrical connection must be carried out in compliance with local regulations.
This appliance must be connected directly to the mains supply.
Ensure the appliance is installed by an authorised person in accordance with AS/NZS 3000
wiring rules.
FIG. 8
To Next Page
Loading...
Need help?
General
